Instructions / Assembly

F6225
Installation & Operating Instructions for the
Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
CODE SWITCH
1. CODE SWITCH: Codes are set by pushing dip switches up or down. It is imperative that the code
used for both transmitter and receiver is exactly the same, otherwise remote controlle
r will not work.
Please note
the code switch will enable you to operate a second remote controller independently
. For
example, if you have two ceiling fans with 2 remote control units, set 2 different codes for each set of
transmitter/receivers.
This means you can operate each ceiling fan independently
.
2.
Your remote control is ready for use after battery installation(need 12V battery 1pc).
ON DIP
1234
ANTENNA
DIP SWITCH
TO OPEN BATTERY HOUSING
COVER BY PRESS DOWN AND
SLIDE OUT
RECEIVER
FUNCTIONS OF TRANSMITTER
: Press and release immediately to turn on or off the light.
Press and hold to dim or brighten lights to the desired level and
release. (Only for the tungsten bulb.)
Ceiling Fan Remote Control
Wiring Connection
TRANSMITTER
To install the Transmitter Wall
Mount Holder with two screws.