Installation Guide

FREEZER FEATURES AND USE
BEFORE FIRST USE:
To prevent any internal damage, it is very important to keep refrigeration units
(like this one) upright throughout their journey. Please leave it standing upright
and outside the box for 24 HOURS before plugging it in.
INTRODUCTION TO THE FREEZER’S FUNCTIONS
Display Controls
When turning on for the first time, the display screen will be a full display for 2
seconds, Then display will revert to the actual internal temperature,
The LCD display shows the actual internal temperature. Your freezer when it is
first turned on, will have a factory setting of 0℉.
Control Panel Auto-Lock
Your freezer has an automatic control panel lock. You may manually activate or
deactivate the control panel lock by pressing the control pad button + and
–simultaneously.
The control panel lock will automatically activate if the control panel is not
touched for 30 seconds.
Memory Function
If turned off, this freezer will remember any settings in place and will work
according to those settings once it’s turned on again.
Temperature Setting
Press the increase temperature button to increase the temperature one degree
at a time. Press the decrease temperature button to decrease the temperature
one degree at a time. The display will show actual internal temperature
5seconds later.
The adjust temperature range of the freezer is -11to 7℉, The display is in
Celsius only .
Note: It is normal for the actual temperature to vary slightly during normal
operation.
QUICK-FREEZE
If temp setting below 3℉,press quick-freeze button, your freezer will under
quick-freeze function. The display show “ ”, the Compressor will continuous
working 24hours.
Temperature appears too warm, Display show error “EH”
When the actual internal temperature is too much high than setting temp.
Display show error “EH”
Possible Causes & Solutions
• Frequent door openings.
• Check gaskets for proper seal.
• Check to see if doors are completely closed.
• Contact customer support.
6