Users Manual

10
ENGLISH
CONSOLE OPERATION
WIRELESS HEART RATE
To connect your ANT+ or Bluetooth SMART heart rate device to the
console, touch and then touch HEART RATE DEVICE PAIRING.
The heart rate function on this product is not a medical device. The heart rate reading
is intended only as an exercise aid in determining heart rate trends in general. Please
consult your physician.
When used in conjunction with a wireless chest strap or arm band, your heart rate can be
transmitted wirelessly to the unit and displayed on the console.
WARNING!
Heart rate monitoring systems may be inaccurate. Over exercising may result
in serious injury or death. If you feel faint, stop exercising immediately.
* Supported standards with carrier frequency of 13.56 MHz include; ISO 14443 A, ISO 15693, ISO 14443 B, Sony Felica, Inside Contact-less (HID iClass), and LEGIC RF.
TARGET TRAINING WORKOUT
1) Start pedaling until the default screen appears.
2) Either swipe right or tap the metric box with an orange triangle to take you
directly to the desired screen.
3) Once on your desired screen, tap the large metric or the target icon to set your
training goal and then touch . The LED lights now become associated to that
target.
LED LIGHTS
Target training programming uses bright color lights on the top and sides of the
console to gauge effort and keep everyone on track of their goals. These lights may
be turned on or off in the workout setup by pressing LIGHTS ON or LIGHTS OFF. The
color indicators are: BLUE = below target, GREEN = on target, RED = above target.
MANAGER MODE
To enter manager mode, press and hold the MATRIX logo in the center of the screen
for 10 seconds. Then enter 1001 and touch .
POWER ACCURACY
This bike displays power on the console. The power accuracy of this model has been
tested using the test method of ISO 20957-10:2017 to ensure a power accuracy within a
tolerance of ±10 % for input power ≥50 W, and within a tolerance of ±5 W for input power
<50 W. The power accuracy was verified using the following conditions:
Nominal Power Rotations per minute measured at crank
• 50 W 50 RPM
• 100 W 50 RPM
• 150 W 60 RPM
• 200 W 60 RPM
• 300 W 70 RPM
• 400 W 70 RPM
In addition to the above testing conditions, the manufacturer tested the power accuracy
at one additional point, using a crank rotation speed of approximately 80 RPM (or higher)
and comparing the displayed power to the input (measured) power.