Users Manual
4
ENGLISH
ASSEMBLY
UNPACKING
Unpack the equipment where you will be using it. Place the carton
on a level flat surface. It is recommended that you place a protective
covering on your floor. Never open box when it is on its side.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly
and usage. Please do not wipe this o. If you have diculty,
a light application of lithium grease is recommended.
WARNING!
There are several areas during the assembly process that
special attention must be paid. It is very important to follow
the assembly instructions correctly and to make sure all parts
are firmly tightened. If the assembly instructions are not
followed correctly, the equipment could have parts that are not
tightened and will seem loose and may cause irritating noises.
To prevent damage to the equipment, the assembly instructions
must be reviewed and corrective actions should be taken.
NEED HELP?
If you have questions or if there are any missing
parts, contact Customer Tech Support.
TOOLS REQUIRED:
F 3 mm Allen Wrench
F 5 mm Allen Wrench
F 10 mm Allen Wrench
F Flat Wrench (15mm/17mm 325L)
F Phillips Screwdriver
PARTS INCLUDED:
F 1 Main Frame
F 1 Front Stabilizer Tube
F 1 Rear Stabilizer Tube
F 1 Handlebar Set
F 1 Transport Handle
F 1 Bicycle Saddle
F 2 Pedals
F 1 Console
F 1 Hardware Kit
SEAT AND HANDLEBARS: HOLD WITH ONE HAND WHILE
ADJUSTING HEIGHT. ENSURE CLAMP IS FULLY
ENGAGED PRIOR TO USE.
USE THE STATIONARY TRAINING EQUIPMENT IN A
SUPERVISED ENVIRONMENT UNDER THE DIRECT
SUPERVISION OF A TRAINED INSTRUCTOR.
SPINNING PEDALS CAN CAUSE INJURY.
THIS EXERCISE BICYCLE DOES NOT HAVE A
FREEWHEEL AND PEDAL SPEED MUST BE
REDUCED IN A CONTROLLED MANNER.
WARN ING
KEEP CHILDREN UNDER THE AGE OF 14 AWAY FROM
EXERCISE EQUIPMENT.
ALL WARNINGS AND INSTRUCTIONS SHOULD BE READ
AND PROPER INSTRUCTION OBTAINED PRIOR TO USE.
USE THIS EQUIPMENT FOR ITS INTENDED PURPOSE
ONLY. CONSULT A PHYSICIAN BEFORE USING THIS
EQUIPMENT.
SET UP AND OPERATE THE STATIONARY EXERCISE
BICYCLE ON A SOLID LEVEL SURFACE. CARE
SHOULD BE TAKEN IN MOUNTING AND
DISMOUNTING THE STATIONARY EXERCISE
BICYCLE. BEFORE DISMOUNTING,
BRING THE PEDALS TO A
COMPLETE STOP.
CAUTION
SERIAL NUMBER
MODEL: CXP MATRIX TARGET TRAINING CYCLE
* Use the information above when calling for service.