User's Manual
Table Of Contents
- 1Intended use
- 2Safety information
- 3Overview
- 3.1Introduction
- 3.2Product composition
- 3.2.1Main Box
- 3.2.2Nodes
- 3.2.3Straps
- 3.2.4Computer and Camera
- 3.3Working conditions
- 3.4Transport and storage conditions
- 3.5Symbols used in this product
- 4Specifications and parameters
- 4.1Specification
- 4.2 Indicator light description
- 4.2.1Main Box indicator
- 4.2.2Node indicator
- 5Instructions for use
- 5.1 Preparation for use
- 5.1.1Charging
- 5.1.2Device connection
- 5.1.3Venue set-up
- 5.2 Strap-on wear
- 5.2.1Effect after wearing
- 5.2.2Chest strap
- 5.2.3Waist strap
- 5.2.4Wrist strap
- 5.2.5Thigh strap
- 5.2.6Ankle strap
- 5.2.7Vamp strap
- 5.3Node Wearing
- 5.3.1Node snap-in
- 5.3.2Node pull-out
- 5.4Getting started with the software
- 5.4.1Visit the Wearable Motion and Gait Quantification
- 5.4.2New assessment
- 5.4.3Enter the assessment name and description of the a
- 5.4.4Add a check
- 5.4.5Select an assessment template to carry out the ass
- 5.4.6Enter patient information
- 5.4.7Start assessment
- 5.4.8View the assessment report
- 5.4.9Other functions
- 5.5After use
- 5.5.1End of use
- 6Cleaning and disinfection
- 6.1 Cleaning the main chassis and nodes
- 6.2 Cleaning straps
- 7Maintenance and Care
- 8Exceptions and their handling
- 9Cautions
- 10Contraindications
- 11Electromagnetic compatibility information
- 12Name and content of hazardous substances
- 13REGULATORY INFORMATION
- 14Quality commitment
- 15Disposal
- 16Copyright and Responsibility
- 18 -
5.3Node Wearing
5.3.1 Node snap-in
Please put the nodes on in the corresponding order. When snapping the nodes in, please note that the side
with the numbered letters faces outwards and the nodes are snapped in when you hear a "pop". Do not force the
nodes in with the non-slip side facing inwards.
Figure 16 Node snap-in
节点
位置
节点
位置
A
Back Waist
F
Right Thigh
B
Chest
G
Left Ankle
C
Left Wrist
H
Right Ankle
D
Right Wrist
I
Left Vamp Upper
E
Left Thigh
J
Right Vamp Upper
Table 9
Description of
node wear position
5.3.2 Node pull-out
To pull out the nodes, place four fingers on the bottom of the node clasp with your thumb on the bottom of
the node, palm facing the top of the node, halfway up the node and then push the node out with a little force. Be
careful when pulling out the node that it bounces off with too much force.
Figure 17 Node pull-out










