User's Manual
Table Of Contents
- 1Intended use
- 2Safety information
- 3Overview
- 3.1Introduction
- 3.2Product composition
- 3.2.1Main Box
- 3.2.2Nodes
- 3.2.3Straps
- 3.2.4Computer and Camera
- 3.3Working conditions
- 3.4Transport and storage conditions
- 3.5Symbols used in this product
- 4Specifications and parameters
- 4.1Specification
- 4.2 Indicator light description
- 4.2.1Main Box indicator
- 4.2.2Node indicator
- 5Instructions for use
- 5.1 Preparation for use
- 5.1.1Charging
- 5.1.2Device connection
- 5.1.3Venue set-up
- 5.2 Strap-on wear
- 5.2.1Effect after wearing
- 5.2.2Chest strap
- 5.2.3Waist strap
- 5.2.4Wrist strap
- 5.2.5Thigh strap
- 5.2.6Ankle strap
- 5.2.7Vamp strap
- 5.3Node Wearing
- 5.3.1Node snap-in
- 5.3.2Node pull-out
- 5.4Getting started with the software
- 5.4.1Visit the Wearable Motion and Gait Quantification
- 5.4.2New assessment
- 5.4.3Enter the assessment name and description of the a
- 5.4.4Add a check
- 5.4.5Select an assessment template to carry out the ass
- 5.4.6Enter patient information
- 5.4.7Start assessment
- 5.4.8View the assessment report
- 5.4.9Other functions
- 5.5After use
- 5.5.1End of use
- 6Cleaning and disinfection
- 6.1 Cleaning the main chassis and nodes
- 6.2 Cleaning straps
- 7Maintenance and Care
- 8Exceptions and their handling
- 9Cautions
- 10Contraindications
- 11Electromagnetic compatibility information
- 12Name and content of hazardous substances
- 13REGULATORY INFORMATION
- 14Quality commitment
- 15Disposal
- 16Copyright and Responsibility
- 23 -
configuration and status query on nodes in [settings] - [node configuration].
2
Patient management
The PC application of wearable movement and gait quantitative evaluation system can view, add and modify
patient information in [patient].
5.5After use
5.5.1 End of use
At the end of use, remove the straps and store them; it is recommended that the straps are cleaned
promptly after use.
6 Cleaning and disinfection
6.1 Cleaning the main chassis and nodes
Please use a clean cotton cloth with neutral detergent or clean water to wipe and clean the nodes and the
main box, and dry them with a dry cloth. In case of accidental pollution and disinfection, a cloth stained with
medical alcohol can be used for wiping and disinfection.
Wipe down and dry with a dry cloth.
6.2 Cleaning straps
After each use, please use neutral detergent or medical alcohol to wipe, clean or disinfect.
Please wash your hands regularly with clean water to keep the bandage clean.
7 Maintenance and Care
This product contains precision devices, please keep away from magnetic field environment, long-term
magnetic interference will reduce the performance and affect the service life of the product.
When you have finished using this product, please switch it off promptly.
This product should not be flushed or doused with water.
Do not place any part of this product near an open flame or heat source when in use or storage.
Clean the stained area promptly after use.
Avoid dropping any part of this product when in use or storage.
Do not pull, press or twist the product with force.
This product should be charged in time. When not in use for a long time, it should be stored fully
charged and recharged at intervals of one to two months. Store in a cool, dry environment, avoid