User's Manual

Page | 4
When using optional transmitter
(WST) Wireless Mode
When the transmitter is connected to a source device the
LED will flash intermittently
When the speaker is connected to mains power the LED on the
front of the speaker will light up for 3 seconds then power
off.
Using the remote control, aim at the speaker and press the
Power On button.
The speaker will automatically start searching through the
channels
If a transmitter is connected to a source device that is
operational the speaker will lock on, which is confirmed when
the speaker LED and transmitter LED are the same colour.
Once set, the volume may need to be increased with the
remote control
If the speaker does not find a channel (no working
transmitter) the speaker will power off.
In some cases you may need to find a zone by pressing the
Station button on the rear of the speaker.By pressing the
button briefly, the LED colour on the front of the speaker
changes, press the button until it matches the LED colour on
the transmitter. The speaker can be put in standby mode by
pressing the RED power button on the remote control. This
will turn off the LED completely. To bring the speaker out of
standby press the RED power button again and the volume
will return to the last setting used.
If the speaker is to be left unattended for prolonged periods
remove the plug from the back of the speaker.
If no signal is being received from a transmitter the speaker
will go into search mode. If no signal is found after ten
minutes the speaker will power off.
If a signal is found within that time it will lock on
automatically.The speaker can be reset to default setting
at any time by powering on then holding the YELLOW mute
button for more than 5 seconds, the LED will flash
intermittently then power off. When powering on the system it
will be in the default setting.
201205-WS10i說明書NEW.indd 4 2012/7/3 下午 04:49:44