Owner Manual

SeaTile® Natural Shell Series Installation and Care
SeaTile® Natural Shell Ceramic Back, Seamless or Mesh Back Tiles
• Install tiles carefully to avoid scratching with standard tile adhesives using white latex-modified thin set mortar for the bonding material and only non-
sanded grout with minimal joints. Installation should be performed by experienced installers, familiar with the methods and guidelines set forth by The
American National Standards Institute (ANSI).
• Use only non-abrasive and non-corrosive cleaning agents such as soap and water.
• Load bearing waterproof membranes are recommended in wet locations such as baths and showers.
• After Care: wash down with warm water – spills of staining liquids such as wine, juice, coffee, etc. should be cleaned immediately with warm water and
liquid detergent.
• All tiles should be installed in the same direction.
Finishing: SeaTile
®
Ceramic Back and Laminate Natural Shell series are already coated with a special marine grade polyurethane so it is not necessary to recoat.
Please consult with manufacturer if additional coatings are required.
Product Support: SeaTile® products are supported by brand name national companies. Please consult Matrix Z’s
technical
department, or product representative for further recommendations and/or brand name products for use in the installation. Please refer to our web site
www.matrix-z.com for further information. Please call or e-mail us at [e-mail] for specific questions about our products.
www.matrix-z.com