Specifications

37
CHAPTER 9: PART REPLACEMENT GUIDE
CHAPTER 9: PART REPLACEMENT GUIDE

1) Remove the front shroud as outlined in Section 9.1.
2) Remove four deck screws using a 5mm Allen wrench (Figure A).
3) Remove the deck from the running belt (Figures B & C).
4) Be careful not to pinch fingers during removal / installation of deck board.
5) Deck is waxed on both sides so opposite side surface may be usable.
5) New deck surfaces must ALWAYS be matched to a new running belt.
FIGURE A
FIGURE B
FIGURE C