Product specifications

4.3 ASSEMBLY STEPS U1x

1) Secure the upper console mast to the lower console mast using four bolts

(Z01). Alternately tighten each bolt using a #6 Allen Wrench. Check the

console mast to make sure it is securely fastened.

Z01

Z08

Z01

STEP 3

HANDLEBAR SET

1) Feed the heart rate wires of the handlebar through the small hole located

in the front of the console mast. Pull these wires up through the hole at

the top of the console mast. Attach the handlebar to the console mast

using four bolts (Z01). Tighten with a #6 Allen Wrench.

CONSOLE

1) Remove the four mounting bolts from the back of the console with a Phil-

lips Screwdriver. Plug in the wire harness and the two heart rate wires to

the back of the console. Attach the console to the console mast with the

four bolts removed earlier in this step.

ACCESSORY TRAY

1) Attach the accessory tray to the console mast using two screws (Z08).

Tighten them with a Phillips Screwdriver.

Z01

Z08

Z01

STEP 4

CHAPTER 4: B

ike parts and assembly Guides

R1x_U1x_rev1.1.indd 11 8/6/10 2:50 PM