User guide

112
Chapter 8, Defining Your Adobe Premiere Pro Settings
• Variable bit rate (VBR) Video is compressed at varying data rates
based on the complexity of the video. The target data rate you select is
used as the average data rate for the compression.
$ Min, Ta r g et , and Max sliders Use these sliders to select your desired data
rate. The higher the target data rate you select, the better the video quality
will be. Only the
Tar ge t slider will be available if you selected Constant
bit rate (CBR)
. If you selected Variable bit rate (VBR), all three sliders
will be available so that you can set the minimum, target, and maximum
data rates for the video compression.
3 Under GOP Structure, you can customize the GOP structure for the
MPEG-2 IBP compression as follows:
$ GOP length Determines the number of frames in the GOP (Group of
Pictures).
$ Subgroup length Determines the subgroup length of B-frames and
P-frames in the GOP, after the initial I-frame. For example, a subgroup of
3 appears as “BBP,” and a subgroup of 2 appears as “BP.” The available
subgroup lengths depend on your selected GOP length.
4 Under Profile, select one of the following MPEG-2 profiles:
$ 4:2:0 This profile uses 4:2:0 luminance/chrominance sampling and is
suitable for broadcast transmission and distribution on DVD. You must
select this profile if you’re exporting to an .m2v file for DVD authoring.
$ 4:2:2 This profile uses 4:2:2 luminance/chrominance sampling and is
suitable for high-quality distribution and archiving.
5 Under Motion Estimation, drag the slider to adjust the quality of the
motion estimation used for the video compression. The default setting gives
good results for most video. However, if you have a lot of fast motion in your
video, such as fast-paced sports footage, you can get better results by
dragging the slider to the right (towards
Slow/High quality). This improves
the quality of the motion estimation, but decreases the speed of the video
compression. Alternately, if you have mostly slow-paced video, you may
want to drag the slider to the left (towards
Fast/Low quality) to decrease
the quality of the motion estimation and speed up the video compression.
6 Click OK to save your settings.
Axio Installation and User Guide.book Page 112 Monday, July 14, 2008 8:00 AM