User guide

Attaching the rubber feet to X.linkLE

You can use the adhesive rubber feet provided with the X.linkLE breakout box if

you’d like to mount the breakout box on your desktop. To do this, peel the rubber

feet from their adhesive backing sheet and attach them to the corresponding

round indentations at the corners on the bottom of the breakout box.

¦NoteIf you later choose to mount your X.linkLE breakout box to a standard

19” rack using the rackmount brackets as explained in the following section, the

breakout box may not fit in the rack unless you remove the adhesive rubber feet.

Attaching the rackmount brackets to X.linkLE

You can use the supplied rackmount brackets to mount your X.linkLE breakout

box to a standard 19” rack.

1 Unpack the two rackmount brackets and their eight mounting screws.

²Caution Use only the screws supplied with your Matrox Axio LE kit to

attach the rackmount brackets to your X.linkLE breakout box. If you use

screws that are larger or longer than the ones supplied, you can damage your

equipment.

2 With the rackmount brackets positioned so that the bracket face is towards

the front of the X.linkLE breakout box, align the screw holes on each

Adhesive rubber foot (x4)

X.linkLE breakout box (partial view)

Axio Installation and User Guide.book Page 41 Monday, July 14, 2008 8:00 AM