User guide

USA
FCC Compliance Statement
Remark for the Matrox product support by this guide (Matrox EpicA TC2, Matrox EpicA TC2-Lite)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna •
Increase the separation between the equipment and receiver • Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected • Consult the dealer or an experienced radio/TV technician for help.
WARNING Changes or modifications to this unit not expressly approved by the party responsible for the compliance
could void the user’s authority to operate this equipment. The use of shielded cables for connection of the monitor to
the card is required to meet FCC requirements.
Declaration of conformity of a Class B digital device according to the FCC rules
We, the Responsible Party Matrox, 625 State Route 3, Unit B, Plattsburg, NY 12901 • Telephone: [phone]
(extension 2026) • Attention: Conformity Group Matrox
Declaration The Matrox hardware products supported by this guide (Matrox EpicA TC2, Matrox EpicA TC2-Lite)
comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) these devices may not
cause harmful interference, and (2) these devices must accept any interference received, including interference that may
cause undesired operation. Any question regarding this declaration should be forwarded to the above coordinates.
CANADA
(English) Industry Canada Compliance Statement
Remark for the Matrox product support by this guide (Matrox EpicA TC2, Matrox EpicA TC2-Lite) These digital
devices do not exceed the Class B limits for radio noise emission from digital devices set out in the Radio Interference
Regulation of Industry Canada.
(Français) Conformité avec les exigences du ministère de l’Industrie Canada
Remarque sur les produits matériels Matrox couverts par ce guide (Matrox EpicA TC2, Matrox EpicA TC2-Lite)
Ces appareils numériques n’émettent aucun bruit radioélectrique dépassant les limites applicables aux appareils
numériques de Classe B prescrites dans le Règlement sur le brouillage radioélectrique édicté par Industrie Canada.
USA
FCC Compliance Statement
Remark for the Matrox product support by this guide (Matrox EpicA TC4) This equipment has been tested and
found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
WARNING Changes or modifications to this unit not expressly approved by the party responsible for the compliance
could void the user’s authority to operate this equipment. The use of shielded cables for connection of the monitor to
the card is required to meet FCC requirements.