User Manual-Mac

101
Working with Adobe Premiere Pro
a In Premiere Pro, specify your playback settings as detailed in “Defining
your playback settings” on page 84. When specifying your playback
settings, make sure to select the
Enable CC overlay on output (Adobe
CS6)
option in the Matrox Player Setup dialog.
b From the Program monitor pop-up menu, choose Closed Captioning
Display > Enable
.
c Play back your sequence.
Setting up Matrox device control
Matrox device control lets you control any device that supports the RS-422
SMPTE time code protocol when capturing or exporting material to tape in
Adobe Premiere Pro. To use device control, you must connect your source device
or recorder as follows:
• MXO2, MXO2 Rack, and MXO2 LE Connect the RS-422 connector on
your MXO2 hardware to the serial device control port on your source device
or recorder using an RS-422 serial cable (see “MXO2 RS-422 serial
connection” on page 19, “MXO2 Rack RS-422 serial connection” on
page 30, or “MXO2 LE RS-422 serial connection” on page 39).
¦NoteWhen using an analog RS-422 device on MXO2, MXO2 Rack, or
MXO2 LE, you must genlock to an external broadcast-quality analog sync
source. If you’re using an SDI RS-422 device and you don’t have an external
broadcast-quality analog sync source, you can genlock to your SDI video
source for capture. For export to tape, you can set your genlock source to the
MXO2 internal reference and configure the setting on your deck to genlock
to the SDI video input. For details on how to set your genlock source, see
“Specifying your genlock settings” on page 56.
• MXO2 Mini MXO2 Mini does not feature an RS-422 serial connector.
You can, however, use a suitable serial adapter to connect the serial device
port on your source device or recorder to your computer. For a list of
supported device control adapters, see the Matrox MXO2 Support section of
our website at www.matrox.com/video/support.