User Manual-Mac

105
Working with Adobe Premiere Pro
¦NoteAdobe Premiere Pro will automatically render sections that have a red
render bar when you start an export to tape, but to avoid having dropped frames
you must render both the red and yellow sections before performing a Matrox
export to tape.
4 Make sure that you’ve properly connected your RS-422 recorder and
configured Matrox device control as explained in “Setting up Matrox device
control” on page 101.
¦NoteWhen exporting to tape, Matrox uses a preroll of five seconds. This
value is hardcoded and cannot be changed. The
Preroll and Timecode Offset
options available in Premiere Pro are ignored when using Matrox device
control for exporting to tape.
5 Load a striped recordable tape into your recorder, and set your recorder to
Remote or VTR mode.
6 Make sure that the sequence is activated, and then choose File > Export >
Ta p e
to open the Matrox Export to Tape panel.