User Manual-Mac

171
Outputs
Output connector descriptions
This section describes the Matrox MXO2, MXO2 Rack, and MXO2 LE outputs.
For MXO2 Mini outputs, see “Output connector descriptions (MXO2 Mini)” on
page 173.
HD to SD downscaling, SD to HD upscaling, and cross conversion are supported
on all video outputs simultaneously. To select your video output settings, see
“Specifying your video output settings” on page 60. You can also map any audio
track in your video application to any MXO2 audio output (see “Specifying your
audio output settings” on page 64). For a list of the video formats that you can
output from the MXO2 outputs, see “Video formats supported on MXO2
outputs” on page 186.
¦NoteDepending on your MXO2 hardware, some of the following connectors
may not be available or may be available in a limited capacity only. Some
connectors on your MXO2 hardware may not appear exactly as shown below.
HDMI Provides an output for HD/SD HDMI video, and up to
eight channels of embedded audio, to a digital HDMI device.
HDCP is not supported on this output. This output supports 1:1
pixel mapping for accurate monitoring on your HDMI display
of NTSC, PAL, 1280×720, and 1920×1080 video. Connect a
standard HDMI video/audio cable to an HDMI monitor, VTR,
or other digital HDMI device. You can also connect directly to a
home theatre system for surround sound monitoring.
¦NoteThe HDMI output supports YUV and RGB
devices. To set the HDMI output type, see “Specifying
your video output settings” on page 60.
HDMI monitor calibration is available through this output. Use
the Matrox HDMI Calibration Utility to calibrate your HDMI
monitor (see Chapter 8, “Calibrating Your HDMI Monitor for
Video”).