Specifications

August 2018 xcore ascend
™
Page 4 of 6
Maintenance Instructions
Precautions
Follow facilities Standard Operating Procedures (SOP). All Safety Data Sheets and product label instructions must be
read, understood and followed prior to using the product.
Initial Cleaning (after installation)
xcore ascend
™
does not require initial cleaning.
Finish
xcore ascend
™
does not require any coats or finish to be applied.
Daily Cleaning
Damp mop when required, using a nonabrasive sponge or cloth with either Windex
®
or a diluted neutral
cleaner/degreaser as often as required.
Additional Information
Do not use dust mops treated with oils or silicones, acetone, strong alkaline cleaning agents, scouring powder, strong
solvents, or abrasive cleaning pads, as these can damage the product.
Note: These instructions supersede any verbal or written instructions from Mats Inc. representatives, and must be
followed in order for the Mats Inc. xcore ascend
™
warranty to be in effect.
Limited Warranty
Mats Inc. (“SELLER”) warrants that xcore ascend
™
(the “Product”) sold to the first end user (“END USER”) will be free of
manufacturing defects in materials provided that they are stored, installed, and maintained strictly in accordance with the
SELLER’s instructions for a period as provided in Section IV of this Limited Warranty.
Receipt and installation of the Product constitutes acceptance of this Limited Warranty and all of its terms,
conditions, limitations, and disclaimers.
This Limited Warranty applies only to installations sold to the first END USER of the Product and becomes void on the
transfer or sale of the Product or the use of the Product by any party other than END USER.
I. Installation and Maintenance Requirements
This Limited Warranty applies only if:
(A) The Product is installed on a properly prepared subfloor as detailed within the product installation instructions; and
(B) The Product must be installed properly following the installation instructions by professional flooring installers
experienced at installing commercial resilient floor covering products and having sufficient professional liability
insurance coverage (aka Errors and Omissions Insurance) for the project; and
(C) The product is maintained according to the SELLER’s instructions furnished to END USER at the time of
purchase; and
(D) The Product is not misused or abused, and there is no evidence of mishandling, neglect, modification or repair
without the approval of SELLER, or damage done to the product by anyone other than SELLER.
II. Method for Obtaining Warranty Service
To obtain a replacement product under this Limited Warranty, END USER must