User`s manual

20
The mainboard accommodates two SDR SDRAM and two
DDR SDRAM modules. You must install at least one module
in any of the four slots. Each module can be installed with up
to 1 GB of memory; total memory capacity is 4 GB.
Refer to the following to install the memory modules.
1. Push the latches on each side of the DIMM slot down.
2. Align the memory module with the slot. The DIMM
slots are keyed with notches and the DIMMs are keyed
with cutouts so that they can only be installed correctly.
3. Check that the cutouts on the DIMM module edge
connector match the notches in the DIMM slot:
Cutout
Notch
Latch
Latch
Cutouts
Notches
Latch
Latch
DDR SDRAM Module SDR SDRAM Module
4. Install the DIMM module into the slot and press it firmly
down until it seats correctly. The slot latches are lever-
ed upwards and latch on to the edges of the DIMM.
5. Install any remaining DIMM modules.