User`s manual

25
3. Plug the correct connector on the FDD cable for the
5.25-inch or 3.5-inch drive into the FDD connector (B).
4. Plug a power cable from the case power supply into
the power connector on the FDD.
When you first start up your system, go immediately to the
Setup Utility to configure the floppy diskette drives that you
have installed. See Drive A/Drive B (1.44M, 3.5 in./None) on
page 39 for more information.
Installing Add-on Cards
This mainboard has five 32-bit PCI (Peripheral Components
Interconnect) expansion slots, one 4xAGP slot, and one CNR
slot.
4xAGP Slot
The 4xAGP slot is used to install a graphics
adapter that supports the 4xAGP specifica-
tion and has a 4xAGP edge connector.
PCI Slots
PCI slots are used to install expansion cards
that have the 32-bit PCI interface.
CNR
The Communications Networking Riser
(CNR) slot can be used to insert a CNR card.
Note:
Before installing an add-in card, check the docu-
mentation for the card carefully. If the card is not
Plug and Play, you may have to manually configure
the card before installation.
CASFAN1
IDE 2
CD1
AGP1
PCI1
PCI2
PCI3
PCI4
PCI5
CNR1
J1
BT1
USB2
USB3
JP1
JP3
JP4
WOL1WOM1
SPKR1PANE L1
FDD1
J4
J5
CD2
IDE
1
11
1
1
11
1
1
11
1
1
11
1
1
11
1
1
11
1
1
11
1
1
11
1
AGP slot
PCI slots
CNR slot