User's Manual

q
w
1
Vehicle
2
Transmitter
I. CONTENTS/ FEATURES
1
Battery door
2
ON/OFF switch
3
Twin PowerScrews
1
Driving controls
2
Battery Door
3
Antenna
SMART CIRCUITRY
Your new vehicle is equipped with advanced “Smart Circuitry” designed
to protect its electronic components under extreme operating conditions.
If your vehicle stalls or gets stuck during use, it will automatically power
down. Simply release the transmitter controls for a few seconds, then press
the left control to resume normal operation.
NOTE: When your vehicle powers up again, you may notice some
movement of the vehicle body and the PowerScrews. This may also happen
if the vehicle is switched off with the PowerScrews angled, and then turned
back on. This is completely normal: it’s an automatic system designed
to return the vehicle to normal driving position. Once the movement has
stopped, you may simply resume normal operation.
CAUTION:
Surfaces may become hot and cause
burns if electronics get wet. Do not operate vehicle
through water or snow.
CAUTION:
To prevent entanglement, keep all hair
away from moving parts.
2
1
2
1
1
3
3
3
8+
Keep these instructions for future reference as they contain
important information. IMPORTANT: Please read all
“Consumer Information” before operating your vehicle.
CAUTION – ELECTICALLY OPERATED PRODUCT: Not
recommended for children under [specify age grade] years
of age. As with all electric products, precautions should be
observed during handling and use to prevent electric shock.
Asst. X2874
X2875/ X2876-0920
®
©2012 Mattel. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Relations 1-888-
557-8926. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty., Ltd.,
Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312. Mattel East Asia Ltd., Room 1106, South Tower, World
Finance Centre, Harbour City, Tsimshatsui, HK, China. Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.(993532-P) Lot 13.5,
13th Floor, Menara Lien Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ. Tel:03-78803817, Fax:03-78803867. service.
mattel.com
Questions or problems with your product? DON’T RETURN IT TO THE STORE! Just call us for help.
U.S. consumers may also register their products at this number.
Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities.
BATTERY CHARGING/CARE
CAUTION: Use only the charger supplied
with this toy. Do not use any other
charging source.
Use only HOT WHEELS
®
R/C TMH
®
FlexPak®
®
NiMH battery packs. Other batteries may leak or
rupture, causing personal injury and damage.
1. Plug the battery charger into standard
wall outlet.
2. Hold the battery pack fully open, with the
metal contacts at the top, as shown. The labels
marked 1 and 2 in the upper left-hand corner
should be facing you. Now slide the battery
pack securely into the charger.
3. To disconnect, push the red button on the side
of the charger. Hold the red button down while
you slide out the battery pack.
4. After charging, the battery pack may feel warm.
This is normal for fully charged batteries.
5. New battery packs must be charged for 5
1/2 hours the first two times charged. After
that, subsequent charges will require 4 hours.
Charging the battery pack for more than
4 hours will not give you a longer running time.
4 hours is all that is required for a fully charged
battery pack.
6. Unlike NiCd (Nickel-Cadmium) rechargeable
batteries, your TMH
®
FlexPak
®
battery pack
may be recharged at any time irrespective of
the level of charge remaining in the battery. You
do not have to wait until the battery pack is fully
discharged to recharge it.
7. After use, the battery pack will be hot! Wait at
least 20 minutes until the battery pack cools
down before recharging. Recharging a hot
battery will greatly reduce the number of times
your battery pack can be recharged.
1
2
1250mAh
TMH
®
RECHARGEABLE BATTERY INFORMATION:
DO NOT RECHARGE BATTERY PACK IF
IT IS HOT. ALLOW IT TO COOL BEFORE
RECHARGING.
DO NOT RECHARGE A BATTERY PACK THAT
SHOWS LEAKAGE OR CORROSION.
DO NOT DISASSEMBLE THE BATTERY
PACK. THE BATTERY PACK IS A SEALED
RECHARGEABLE NICKEL-METAL HYDRIDE
BATTERY PACK.
EXERCISE CAUTION IN HANDLING A HOT
BATTERY PACK.
IF BATTERY PACK AND/OR CHARGER ARE WET,
THOROUGHLY DRY BEFORE CHARGING.
DO NOT RECHARGE NON-RECHARGEABLE
BATTERIES.
DO NOT DISPOSE OF THE BATTERY PACK
IN A FIRE.
Note to Adults:
Recharge battery pack only under adult
supervision.
Periodically examine this product for damage to
the plug, housing, or other parts that may result
in the risk of fire, electric shock or injury. If the
product is damaged, do not use it .
The transformer is not a toy.
This battery charger is intended to be correctly
oriented in a vertical or floor mount position
BATTERY DISPOSAL
Unlike NiCd (Nickel-Cadmium) rechargeable
batteries, your TMH
®
FlexPak
®
NiMH battery pack
requires no special procedures or precautions
for disposal. However, as with all products,
you should dispose of your battery pack in an
environmentally responsible and considerate
manner.

Summary of content (2 pages)