User Manual

Table Of Contents

After you determine which (if any) LIT-UP Discard Pile you want to play on, when you lay your card down make sure to press down ﬁrmly

until you hear a “beep.” The lights will rotate to be ready for the next player.

NOTE: DO NOT PRESS DOWN FOR MORE THAN TWO SECONDS OR IT WILL RESET THE CARD COUNTER (MORE ON THIS LATER).

You may only play to ONE Discard Pile per turn.

PLAY A CARD IN A DISCARD PILE

If a Discard Pile gets too many cards, it will “overload”. When this happens, you will hear the overload tone and a number will ﬂash in the

Center Display. The player who played the card that caused the overload must draw the indicated number of cards from the Draw Pile

(anywhere between 1-4 cards). Once you have drawn your cards, press the Go button to re-set the unit for the next player in current order.

NOTE: after a Discard Pile has approximately 20 cards on it, remove those cards, returning only the top card to continue the Discard Pile.

This will prevent the pile from false triggering. Place the removed cards to the side. If you run out of cards in the Draw Pile, shufﬂe the

removed cards and place them facedown to create a new Draw Pile.

OVERLOAD

Turn the unit over and make sure the ON/OFF switch is on “off.” Next,

switch the Timer Switch on the bottom toward the Timer Icon. Then,

turn the ON/OFF switch back to “on.”

Press the Go button to begin.

Timer Mode is a fast-paced version of the Regular Mode where you

have to play quickly. (Not for the faint of heart)

Once your turn begins, you will have only seconds to play a card on an

available Discard Pile (remember to press and activate the card

counter). The time is counted down on the Center Display so hurry up!

Once you play your card, the timer will re-set for the next player and

the count-down will start again.

If you can’t complete your turn before time runs out, you must take back any cards you tried to play and draw 6 cards from the

Draw Pile to add to your hand. (That’s right…6 cards!)

Once you have drawn your cards, press the Go button to re-set the unit for the next player in current order.

If you can’t play a card from your hand on your turn, you must draw a card to play. If you still can’t play, you must press one of the

available Discard Piles to activate the card counter before the timer expires. Remember, if the timer ever expires on your turn, you

must draw 6 cards.

Press the Go button to re-set the unit for the next player in current order.

If a Discard Pile overloads on your turn, the timer stops, and the game is paused. You must draw the number of cards indicated in

the Center Display and then press the Go Button to re-set the unit for the next player in current order.

Play continues until one player gets rid of all their cards (see “Going Out”).

TIMER MODE

X/S O I

ONOFF

Each Discard Pile also has a Card Counter Light that indicates the

condition of the pile. The more you play to a Discard Pile, the Card

Counter light will change from GREEN (safe), to YELLOW (caution), to

RED (close to OVERLOAD), so be careful!

CARD COUNTER DISPLAY

SAFE CAUTION

close to

OVERLOAD!

Correct Language Conﬁgurations