Installation Guide

9
10. INSTALLING THE LED
LIGHT KIT AND
DECORATIVE COVER
1. Raise and hold the LED light kit close to
the mounting plate and proceed to do the
wire connections. Make the 2-pin wire
connections: (Fig. 14)
- White to white
- Black to black
2. Tuck the connections neatly into the
mounting plate and Install the LED light kit to
the mounting plate using the two screws
provided. (Fig. 14)
3. Raise decorative cover up against the
LED light kit and secure it to the fan by
turning the decorative cover clockwise until
snug. DO NOT OVERTIGHTEN. (Fig. 14)
LED
light kit
Mounting plate
Connectors
Screws
Decorative
cover
Figure 14
Figure 13
9. ATTACHING THE
MOUNTING PLATE
1. Remove 1 of the 3 screws from the
mounting ring and keep it for future use.
Loosen the other 2 screws. (Do not remove)
2. Place the key holes on the mounting plate
over the 2 screws previously loosened from
the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 13)
Screws
Mounting ring
Mounting
plate