Installation Guide

10
Figure 17
Figure 15
Figure 16
ON ECE
1234
Restore power to ceiling fan and test for proper
operation.
A. I, II, III, IV, V and VI button:
These six buttons are used to set the fan speed as
follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
B. button:
This button turns the fan off.
C. Reverse button:
This button is to control fan direction
D. Light button:
This button is to control light ON or OFF and also controls
the brightness setting.
E. SET code setting button:
Your DC brushless motor is equipped with automatically
learned type remote control and a wall control. If two fans or
more in a house, it is recommended that you not use the
factory code settings. Change codes setting to any other
combination of dip switch setting to avoid fan interference
issues, but users need to do control setting process as
below once the code setting is changed. Please refer the
"D" "SET" code setting button section. Follow the below
steps to set the remote control:
The auto learning function will only mandate within 60
seconds when turning the fan’s AC power ON.
a) Select desired frequency from the transmitter.
b) From the wall or remote transmitter, press the “SET”
button, and hold the “SET” button for over 10 seconds.
Once the receiver has detected the frequency, the light will
flash twice, and the fan will automatically begin to operate
and start to rotate in the counterclockwise direction and on
the highest RPM for 3 minutes. When counter clockwise
rotation has finished, the fan will automatically reverse to
clockwise direction again to the highest RPM for 3 minutes.
Fan will shut off when the self calibration test has finished.
The total self calibration test will last about 6 minutes.
11. PROGRAMMING YOUR
FAN AND OPERATING
THE REMOTE CONTROL
AND WALL CONTROL
Before programming takes place, fan must be fully
assembled and mounted to the ceiling with blades
attached. You must also choose which control you
will be using for programming the fan, the remote or
the wall control. No other wall control should be used
with this fan but that which was included. Using
another wall control other than ours will damage your
fan and void your warranty.
Install one 23A/12V battery (included). To prevent damage
to transmitter, remove the battery if not used for long
periods of time (Fig. 15 & 16)