Laura Wall Mounted Oscillating Fan READ AND SAVE THESE INSTRUCTIONS FAN RATING AC 120V. 60Hz Please do not use any electric or battery powered tools in the assembly and installation of this or any Matthews Fan Company product.
TOOLS AND MATERIALS REQUIRED Philips screw driver Standard, flat-head screw driver 11 mm wrench Step ladder Wire cutters PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: a. b. c. d. Fan motor assembly Canopy Hanger bracket Remote control and holder with 2 mounting screws e. Allen wrench f.
READ AND SAVE THESE SAFETY AND INSTALLATION INSTRUCTIONS. Consult a licensed electrician if unsure of any point below mentioned. DANGER/WARNING/CAUTION 1. WARNING: TO REDUCE THE RISKS OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Use this unit only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer. B.
9. CAUTION: to reduce the risk of injury to persons, install fan so that bottom edges of fan blades are to be: In Canada, to satisfy CSA requirements: at least 8.3 Ft/2.5 M above the floor and all objects in room. In the US, to satisfy UL requirements: at least 7.0 Ft above the floor and all objects in room. ATTENTION: Installer de sorte que les pieces inferieures soient a au moins 2.5 metres au-dessus du plancher ou du sol. 10.
MOUNTING/INSTALLLATION OF THE FAN AND MAKING THE ELECTRICAL CONNECTIONS Screws Side mount wall junction box Before touching a screw driver thoroughly read these installation instructions. Your new wall fan will require a grounded electrical supply line of 120 volts AC, 60 Hz circuit. The junction box must be securely anchored and capable of withstanding a load of at least 45 lbs. Figure 1 WARNING/CAUTION: Before installing new wall junction box turn off power at service panel. Allen wrench 1.
4. Connect the neutral fan wire to the household neutral wire. (Fig. 3) Ground Neutral 6. Connect the green, fan ground wire to the household ground wire. Hot SUPPLY CIRCUIT 5. Connect the black, fan blade motor wire to a hot, household supply wire. (Fig. 3) Ground White to Neutral 7. After connecting the wires, spread them apart so that the green, ground and neutral, white wires are on one side of the outlet box and the hot, black wire are on the other side of the outlet box.
OPERATING THE TRANSMITTER ON DIP Your DC brushless motor is equipped with an automatically learned type remote control. There are no frequency switches on the receiver; the receiver unit will automatically scan the frequency from the remote control if any changes are made. The frequency settings on the transmitter should be changed only in case of interference or if a second or more ceiling fans with the same type of control system are installed in the same structure. (Fig.
b) From the front of the transmitter, press and hold the “ OFF” button for over 5 seconds, and then press and hold the “ACCESSORYOFF” button for 1 second. c) Press and hold the “ACCESSORY- ON” button for 1 second, and then press the “ACCESSORY- OFF” button, the transmitter will automatically scan the frequency. d) The fan blade will rotate and stop when the self calibration test is completed. Now the fan is ready for using.
CARE OF AND TROUBLESHOOTING YOUR FAN 1. Check hardware bi-yearly. Because of the fan's natural movement some connections may become loose over time. Check the support connections, brackets and blade attachments twice a year. Make sure they are secure. It is not necessary to remove fan from the wall. 2. Clean your fan periodically. This will help to help maintain its new appearance over the years. Use only a lightly water-moistened, lint free cloth to avoid scratching the finish.
