Installation Guide

Figure 21

Figure 22

12. OPERATING YOUR

FAN

Speed settings for warm or cool weather depend on

factors such as the room size. Ceiling height,

number of fans and so on.

NOTE: To operate the reverse function on this fan,

press the reverse button while the fan is running.

Warm weather - (Forward) A downward airflow

creates a cooling effect as shown in Fig. 21. This

allows you to set your air conditioner on a warmer

setting without affecting your comfort.

Cool weather - (Reverse) An upward airflow moves

warm air off the ceiling area as shown in Fig. 22.

This allows you to set your heating unit on a cooler

setting without affecting your comfort.

NOTE: If the self calibration test failed, turn the AC

power off; restore power and process the self

calibration test again.

NOTE: During self calibration test, the remote and

the wall control are non-functional.

NOTE: The learning frequency function and self

calibration test will continue to retain the last set

frequency and calibration set even when the AC

power is shut off. If the frequency is changed the

self calibration test will occur again.

This receiver provides the following protective

function:

1. Lock Rotor Position: The DC motor has a built-in

safety against a stalled or locked rotor condition

(stalled blade rotation). If there is an obstruction or

fault with the motor, the current monitoring function

will automatically turn power off to the motor after 30

seconds. Remove the obstruction and turn the AC

power off. Restore power and re-start fan motor.

2. Over 80W protection: When the receiver detects

motor power consumption which is greater than

80W, the receiver power will be stopped and

operation will immediately discontinue. Wait for 5

seconds and then turn the receiver power back on.