Installation Sheet

7. FINISHING THE

INSTALLATION

STANDARD CEILING INSTALLATION

1. Tuck connections neatly into ceiling outlet box.

2. Slide the canopy up to hanger bracket and place

the key hole on the canopy over the screw on the

hanger bracket, turn canopy until it locks in place at

the narrow section of the key holes. (Fig. 12)

3. Align the circular hole on canopy with the

remaining hole on the hanger bracket, secure by

tightening the two set screws. Note: Adjust the

canopy screws as necessary until the canopy and

canopy cover are snug.

Warning: Make sure tab at bottom of hanger

bracket is properly seated in groove of hanger ball

before attaching canopy to bracket. Failure to

properly seat tab in groove could cause damage to

electrical wiring.

INSTALLING THE FAN HOUSING

Raise the fan housing up against the mounting

plate. The four supports inside the fan housing

should be placed against the four studs on the

mounting plate. Twist the fan housing clockwise

until snug. (Fig. 13)

Figure 12

Figure 13

Outlet box

Hanger

bracket

Canopy

Canopy cover

Screws

Fan

housing

Studs