Instructions / Assembly

10
10. INSTALLING THE LED
LIGHT KIT AND GLASS
SHADE
1. Remove 1 of 3 screws from the mounting
plate and loosen the other 2 screws. (Do not
remove)
2. Raise and hold the LED light kit close to
the mounting plate and proceed to do the
wire connections. Make the 2-pin wire
connections:
(Fig. 16)
- White to white
- Blue to black
3. Place the key holes from the LED light kit
over the 2 screws previously loosened from
the mounting plate, turn light kit until it locks
in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed.
(Fig. 16)
4. Raise glass shade up against the LED
light kit and secure it to the fan by turning the
glass shade clockwise until snug. DO NOT
OVERTIGHTEN.
LED
light kit
Mounting
plate
Connectors
Screws
Glass shade
Figure 16