Installation Sheet

9
8. ATTACHING THE FAN
BLADES
1. Fasten the blades to the blade arms and blade
medallion using the blade attachment screws and
fiber washers. Start a screw with fiber washer into
the blade medallion, but do not tighten. (Fig. 14)
2. Repeat for the remaining blade attachment
screws and fiber washers. Tighten each screw
securely starting with the center screw. Make sure
the blade is straight.
3. Repeat these steps for the remaining blades.
Figure 14
Figure 15
9. ATTACHING THE
MOUNTING PLATE
Step 1. Remove 1 of the 3 screws from the
mounting ring and keep it for future use. Loosen
the other 2 screws. (Do not remove)
Step 2. Place the key holes on the mounting plate
over the 2 screws previously loosened from the
mounting ring, turn mounting plate until it locks in
place at the narrow section of the key holes.
Secure by tightening the 2 screws previously
loosened and the one previously removed. (Fig.
15)
Screws
Mounting ring
Mounting
plate
Blade
Fan
Blade arms
Screw
Fiber
washer
Blade
medallion