Installation Guide

5
Figure 10
Registration
slot
Screw
Safety cable
Figure 9
5. Loosen the two set screws from the central
shaft/top coupling of the motor assembly.
Doing so will allow the down rod to enter the
central shaft. (Fig. 9)
6. Carefully feed the fan wires through the down
rod and pull them taut. Thread the down rod
into the central shaft and tighten well.
Re-tighten the set screws against the
downrod.
7. Slide the coupling cover (with wide end
oriented to floor) down the down rod.
Tighten the set screws of the coupling cover
so that it is secure in its new position.
8. Slide canopy ring (with decorative side
oriented to floor) and canopy (with wide end
oriented to ceiling) onto down rod. Carefully
reinstall hanger ball onto rod. Be sure that
cross pin is in correct position, the set screw
on hanger ball is tight and that the wires are
not twisted.
9. Now lift the motor assembly (fan with blades)
into position and place the hanger ball into
the hanger bracket. Rotate down rod until
the "Check Tab" has dropped into the
"Registration Slot" and the down rod and ball
assembly seat firmly. The down rod and ball
assembly should not rotate if this is done
correctly. (Fig. 10)
10. An additional safety support is provided to
prevent the fan from falling. Secure the
safety cable to the ceiling joist with screw
and washer. (Fig. 10)
Supply wires
Downrod
Coupling cover
Canopy
Canopy ring
Set screws
Hitch pin
Lock pin