Installation Guide

1. To reduce the risk of electric shock, insure
electricity has been turned off at the circuit
breaker or fuse box before beginning.
2. All wiring must be in accordance with the
National Electrical Code and local electrical
codes. Electrical installation should be
performed by a qualified licensed electrician.
3. WARNING: To reduce the risk of electrical
shock and fire, do not use this fan with any
solid-state fan speed control device.
4. WARNING: To Reduce The Risk Of Fire,
Electric Shock, Or Personal Injury, Mount To
Outlet Box Marked Acceptable for Fan
Support of 15.9 kg (35 lbs) or less And Use
Mounting Screws Provided With The Outlet
Box. Most outlet boxes commonly used for
the support of lighting fixtures are not
acceptable for fan support and may need to
be replaced, consult a qualified electrician if
in doubt.
5. The fan must be mounted with a minimum of
7 feet clearance from the trailing edge of the
blades to the floor.
6. To operate the reverse function on this fan,
press the reverse button while the fan is
running.
7. Avoid placing objects in the path of the
blades.
8. To avoid personal injury or damage to the fan
and other items, be cautious when working
around or cleaning the fan.
9. Do not use water or detergents when cleaning
the fan or fan blades. A dry dust cloth or lightly
dampened cloth will be suitable for most
cleaning.
10. After marking electrical connections, spliced
conductors should be turned upward and
pushed carefully up into outlet box. The
wires should be spread apart with the
grounded conductor and the equipment
-grounding conductor on one side of the
outlet box.
11. Electrical diagrams are reference only. Light
kit that are not packed with the fan must be
UL Listed and marked suitable for use with
the model fan you are installing. Switches
must be UL General Use Switches. Refer to
the Instructions packaged with the light kits
and switches for proper assembly.
2
3. SAFETY RULES
WARNING
TO REDUCE THE RISK OF PERSONAL
INJURY, DO NOT BEND THE BLADE
BRACKETS (ALSO REFERRED TO AS
FLANGES) DURING ASSEMBLY OR AFTER
INSTALLATION. DO NOT INSERT OBJECTS IN
THE PATH OF THE BLADES.