Installation Guide

10
Figure 20
Figure 21
12. OPERATING THE
REMOTE CONTROL
Install 12V MN21/A23 battery (included).
To prevent damage to transmitter, remove the
battery if not used for long periods. (Fig. 20)
Restore Power to Ceiling Fan.
A. H, M, L Buttons:
These buttons are used to set the fan speeds
as follows;
L: Low Speed
M: Medium Speed
H: High Speed
B. OFF Button:
This button turns the fan off.
C. ACCESSORY Button:
This button is used to turn on and off the light
kit and also controls the brightness setting.
Press and release this button to turn the light
on or off. Press and hold the button to set the
desired brightness. The light button has an
auto-resume, it will stay at the same
brightness as the last time it was turned off.
D. REV Button:
This button is to control fan direction.
13. OPERATING YOUR
FAN
Speed settings for warm or cool weather depend on
factors such as the room size. Ceiling height,
number of fans and so on.
NOTE:
To operate the reverse function on this fan,
press the reverse button while the fan is running.
Warm weather - (Forward) A downward airflow
creates a cooling effect as shown in Fig. 22. This
allows you to set your air conditioner on a warmer
setting without affecting your comfort.
Cool weather - (Reverse) An upward airflow moves
warm air off the ceiling area as shown in Fig. 23.
This allows you to set your heating unit on a cooler
setting without affecting your comfort.
Figure 22
Figure 23
REV