Installation Guide

4
5. ATTACHING THE FAN
BLADES
1. Fasten the blade assembly to the fan motor
using the screws supplied. Repeat process
with another blade. Tighten each screw and
make sure the blade is straight. (Fig. 5 )
Figure 5
Fan
motor
Screws
Blades
Before touching a screw driver thoroughly
read these instructions.
Warning/Caution: Before installing fan, turn off
power at service panel and check all visible
screws and bolts for tightness.
1. Remove the decorative canopy bottom cover
from the canopy by turning the cover counter
clockwise. (Fig. 6)
2. Remove the hanger bracket from the canopy
by removing the 1 of 2 screws from the
bottom of the hanger bracket and loosening
the other one a half turn from the screw head.
Next, turn the canopy counter clockwise to
removing the hanger bracket from the
canopy. (Fig. 6)
3. Secure the hanger bracket to the ceiling outlet
box using screws and washers included with
your outlet box. (Fig. 7)
4. Remove hanger ball from down rod assembly
by loosening set screws, removing the cross
pin and sliding ball off rod. (Fig. 8)
6. HANGING THE FAN
Ceiling
hanger
bracket
Mounting screws
(supplied with
electrical box)
Hook
Electrical
box
Figure 7
Figure 8
120V Wires
Washers
Downrod
Cross pin
Hanger
ball
Set screw
Figure 6
Ceiling
hanger
bracket
Ceiling
canopy
Canopy
cover