Installation Instructions

nanoLTE E61 AP Hardware Installation nanoLTE E61 AP Commissioning
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 21
3.7 Commissioning Complete
Commissioning the LTE AP is now finished.
From this point on, the LTE AP must be managed from the NOS Client, via the NOS Server.
If the LTE AP has not been pre-provisioned in the NOS Server, it must be pre-provisioned
and configured before it is can enter service.
For information about LTE AP pre-provisioning, see [INST_13400].
3.7.1 Completed On Site Commissioning
If commissioning has been done on site, continue to the on-site hardware installation
procedure (section 4).
Note: The on-site network connection to the LTE AP must also allow a path to the Redirector.
3.7.2 Completed Commissioning in Advance
If commissioning has been done in advance of sending the AP on site, it is advisable to
ensure that the LTE AP will connect to its serving NOS Server prior to sending the AP on
site. To do this:
1) Verify that the LTE AP has been pre-provisioned in the serving NOS.
2) Provide the LTE AP with an appropriate network connection. If the LTE AP has
been commissioned to use IPsec, this means a network connection that will go via
the IPsec Gateway, which is likely to require connection of the LTE AP to an
external network.
Note: The network connection to the LTE AP must also allow a path to the
Redirector.
3) Power up the AP.
4) Use the NOS Client to verify that the LTE AP has connected to its serving NOS.
When the blue delta symbol against the AP object disappears this means that the
LTE AP has connected to the NOS and has also updated its configuration.
5) After verifying this, re-pack the AP so that it is ready for delivery to its intended site.