Installation Instructions
Table Of Contents
- nanoLTE E61 AP Hardware Installation
- Table of Contents
- 1 Introduction
- 2 Installation Overview and Requirements
- 3 nanoLTE E61 AP Commissioning
- 3.1 Requirements for Commissioning with the Web Page
- 3.2 Redirector First Contact and NTP Synchronisation for Software Update
- 3.3 Configure a Commissioning Terminal
- 3.4 Access the Commissioning Web Page for the LTE AP
- 3.5 Optional - Software Download
- 3.6 Configure the Connection to the NOS Server
- 3.7 Commissioning Complete
- 4 nanoLTE E61 AP Hardware Installation
- 5 Troubleshooting
- 6 AP and PSU Regulatory Information
nanoLTE E61 AP Hardware Installation Troubleshooting
NANO_INST_43325 v205_0.6 for N4G_2.5 © ip.access Limited 2019 Page 27
5 Troubleshooting
This section covers the following topics that may be useful for troubleshooting an E61 AP
during installation:
• 5.1 E61 AP Does Not Power Up
• 5.2 E61 AP LEDs
• 5.3 Factory Reset
5.1 E61 AP Does Not Power Up
Check the following:
• Verify the correct power supply is in use and that mains power is available.
or
• Ensure that the Ethernet socket has PoE+ (PoE Plus, not PoE) to power the AP.
5.2 E61 AP LEDs
The front of the E61 has status LEDs:
Note: The Ethernet port on the back of the E61 AP has a link activity LED that flashes when there
is activity on the network connection. The LED is always off when the network cable is
unplugged.