MVK12623 Maverick Strada Brushless MT Red Manual

Turning on the power

Turn on transmitter ﬁ rst and then turn on receiver.

Turn on the transmitter switch and the LED battery

indicator will light up.

Turn on the receiver. The automatic set-up of the factory

set speed control should have been completed. If you

experience any problems with the speed control settings

refer to the Electronic Speed Control Section for correct

setup information.

The Red LED will show if the

installed AA batteries have

sufﬁ cient charge.

The Red LED will ﬂ ash and

there will be an audible beep if

the batteries need replacing.

Power LED

You may need to setup your transmitter to ‘bind’ with the receiver if you change to a new receiver or for any reason

lose signal.

• Place the transmitter and the receiver close to each other (within one meter).

• Turn the power switch on the transmitter to the ON position.

• Press and hold the receiver setup button, then turn the power switch to the ON position.

• The receiver LED will ﬂ ash quickly. Release the setup button after 1 second.

• Press and hold the binding button on the transmitter for 1 second until the LED on the

receiver is continuously lit.

Binding the Transmitter and Receiver

Turning off the power

Turn off receiver ﬁ rst and then turn off transmitter.

If you switch off the transmitter ﬁ rst before the R/C car, you may lose control of the R/C car.

• Turn off the receiver switch.

• Turn off the transmitter switch.

• Disconnect the battery connector from the speed control connector.

Fail Safe Setup

Caution

Any new binding of transmitter & receiver will clear the pre-set fail safe.

With the transmitter and car switched on, press the setup button on the receiver then release. LED will ﬂ ash.

Electric setup

Leave throttle trigger in neutral position, and press the setup button. The LED will ﬂ ash quickly. Once the receiver

LED remains lit, then release the setup button on the receiver.

Nitro setup

Hold full brake on the transmitter, and press the setup button. The LED will ﬂ ash quickly. Release full brake on the

transmitter once the receiver LED remains lit, then release the setup button on the receiver.