Full Product Manual

SETUP AND OPERATION INSTRUCTIONS
TO PREVENT SERIOUS INJURY:
Before loading or unloading turn vehicle’s engine off, set its transmission
in gear or park, engage its emergency brake and block its wheels.
Make sure the Ramps are clean and dry before loading or unloading.
Setup
1. The tailgate the ramps will sit on
and both of the ramps must be
dry and clean. Check for and
tighten any loose hardware.
2. Sit the tongue (angled lip) of the Ramps
on the tailgate. The Tongue Edge must
face down (see Assembly), and fully
contact the truck’s tailgate. Extend the
Safety Chain on each Ramp up
into the inside of the truck bed;
attach each Safety Chain to a secure
attachment point on the truck chassis.
WARNING! CONNECT SAFETY CHAINS
TO SECURE ATTACHMENT POINTS
WITHIN THE TRUCK BED ABLE TO
WITHSTAND THE PULLING FORCE
OF LOADING. THEY MUST ALSO
BE TAUT ENOUGH TO PREVENT
THE RAMPS FROM COMING OFF
THE VEHICLE BEING LOADED.
3. Pull the loading ramps back until
the chains are tight. The entire
tongue portion of the ramps must
fit onto the tailgate; If not, adjust
the Safety Chains accordingly or
shorter chains must be used.
Tongue
Edge
Correct Wrong
[e-mail]
4
1-800-348-5004