Full Product Manual

Chain Adjustment
1. Remove the bolt and washer that
hold the safety chain to the ramp.
2. Reinsert the bolt through a link that
will shorten the chain so the loading
ramp can not be pulled backwards
more than an inch or two.
3. Make sure the washer prevents the bolt
from slipping through the chain link
and tighten the bolt securely.
4. Adjust the other chain to equal length.
4- Wheel ATV Loading and Unloading
• These ramps are for use with 2-wheeled dirt bikes and 4-wheeled ATV’s only.
Do not use these ramps to load/unload 3-wheeled vehicles.
• Do not use these ramps to load or unload any vehicle that weighs more than 1000 lb.
• Do not use these ramps to load or unload any vehicle that is wider than the ramp.
• Do not use these ramps to load or unload any vehicle that is carrying gear on its racks.
• Do not use these ramps if the tailgate on the vehicle being
loaded or unloaded is higher than half each ramp’s length (36″).
WARNING! Riding an ATV while loading or unloading
is dangerous and should not be attempted.
WARNING! Be aware of dynamic loading!
Sudden load movement may briefly create excess load causing the Ramps to fail.
WARNING! All persons not involved in the process must stand clear
of the Ramps and truck. Make sure no pets are nearby.
Loading Using a Winch (not included)
1. The winch and mounting/
connection points must all have
appropriate capacity to pull the
ATV up the ramps safely.
2. ATV Mounted Winch Setup: Unwind
cable from the winch and attach it to a
secure mounting location on the truck,
at the same height as the winch will
be after the ATV has been loaded.
3. Truck Mounted Winch Setup:
Attach the cable to the bottom
front part of the frame.
4. While operating the winch,
stand back and to the side of the
ATV, with the vehicle between
you and the winch cable.
5. Operate the winch to slowly load
the ATV onto the vehicle.
[e-mail]
5
1-800-348-5004