Use and Care Manual

SETUP AND OPERATION INSTRUCTIONS
TO PREVENT SERIOUS INJURY:
Before loading or unloading turn vehicle’s engine off, set its transmission
in gear or park, engage its emergency brake and block its wheels.
Make sure the Ramps are clean and dry before loading or unloading.
Setup
1. The tailgate the ramps will sit on
and both of the ramps must be
dry and clean. Check for and
tighten any loose hardware.
2. Sit the tongue (angled lip) of the Ramps
on the tailgate. The Tongue Edge must
face down (see Assembly), and fully
contact the truck’s tailgate. Extend the
Safety Chain on each Ramp up
into the inside of the truck bed;
attach each Safety Chain to a secure
attachment point on the truck chassis.
WARNING! CO11ECT SAFETY CHAI1S
TO SECURE ATTACHME1T POI1TS
:ITHI1 THE TRUCK BED ABLE TO
:ITHSTA1D THE PULLI1G FORCE
OF LOADI1G. THEY MUST ALSO
BE TAUT E1OUGH TO PRE9E1T
THE RAMPS FROM COMI1G OFF
THE 9EHICLE BEI1G LOADED.
3. Pull the loading ramps back until
the chains are tight. The entire
tongue portion of the ramps must
fit onto the tailgate; If not, adjust
the Safety Chains accordingly or
shorter chains must be used.
Tongue
Edge
Correct Wrong
[e-mail]
4
1-800-348-5004