Use and Care Manual

ManualsBrandsMax Load ManualsAutomotive3-Ton Low Profile Floor Jack with Quick Pump Feature

IMPORTANT SAFETY INFORMATION

SAVE THESE INSTRUCTIONS

Floor Jack Safety Warnings

1. Study, understand, and follow all instructions before operating this device.

2. Do not exceed rated capacity.

3. Use only on hard, level surfaces.

4. Lifting device only. Immediately after lifting, support the vehicle with appropriate means.

5. Do not move or dolly the vehicle while on the jack.

6. Failure to heed these markings may result in personal injury and/or property damage.

7. Lift only areas of the vehicle as specified by the vehicle manufacturer.

8. No alterations shall be made to this product.

9. Never work on, under or around a load supported only by this device.

10. Do not adjust safety valve.

11. Wear ANSI-approved safety goggles and heavy-duty work gloves during use.

12. Keep clear of load while lifting and lowering.

13. Lower load slowly.

14. Apply parking brake and chock tires before lifting vehicle.

15. Lift vehicle only at manufacturer recommended locations.

16. Inspect before every use; do not use if parts are loose or damaged.

17. Do not use for aircraft purposes.

18. The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions

and situations that may occur. The operator must understand that common sense and caution are factors,

which cannot be built into this product, but must be supplied by the operator.

IMPORTANT! Before first use:

&heck hydraulic oil level and fill to 1/4Ǝ below the fill port as needed as stated on page 3. Thoroughly test the

Jack for proper operation. If it does not work properly, bleed air from its hydraulic system as stated on page 3.

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all

text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to Parts List and

Assembly Diagram on page 5.

Functions

U-Joint

Hydraulic Unit

Fill Screw

Safety Valve

Cover

DO NOT OPEN

OR ADJUST

Figure A

SETUP - BEFORE USE

U-Joint (Not Shown)

Saddle

Handle

Handle Socket

Oil Fill Screw

(Not Shown)

Lifting Arm

Rear Caster

customerservice@focus-ontools.com

1-800-348-5004

Summary of content (3 pages)

PAGE 1
IMPORTANT SAFETY INFORMATION Floor Jack Safety Warnings 1. Study, understand, and follow all instructions before operating this device. 2. Do not exceed rated capacity. 3. Use only on hard, level surfaces. 4. Lifting device only. Immediately after lifting, support the vehicle with appropriate means. 5. Do not move or dolly the vehicle while on the jack. 6. Failure to heed these markings may result in personal injury and/or property damage. 7.
PAGE 2
OPERATING INSTRUCTIONS Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product. TOOL SET UP Attaching the Handle 1. Fasten the Upper Handle to the Lower Handle. 2. Loosen the Set Screw and insert the assembled Handle into the Handle Socket. 3. Tighten the Set Screw. Bleeding 1. Loosen the Fill Screw. 2. Insert the Handle into the Handle Socket to operate the Release Valve. 3.
PAGE 3
MAINTENANCE AND SERVICING Procedures not specifically explained in this manual must be performed only by a qualified technician. WARNING:TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. Cleaning, Maintenance, and Lubrication 1. Before each use, inspect the general condition of the Jack.