Use and Care Manual

[e-mail]
2
1-800-348-5004
SPECIFICATIONS
IMPORTANT SAFETY INFORMATION
1. Assemble only according to these instructions. Improper assembly can create hazards.
2. Wear ANSI-approved safety goggles and heavy-duty work gloves during assembly.
3. Keep assembly area clean and well lit.
4. Keep bystanders out of the area during assembly.
5. Do not assemble when tired or when under the influence of alcohol, drugs or medication.
6. Weight capacity and other product capabilities apply to properly and completely assembled product only.
USE PRECAUTIONS
1. Study, understand, and follow all instructions before operating this device.
2. Do not exceed rated capacity.
3. Use only on hard, level surfaces.
4. Center load on Jack platforms.
5. Lift only using tires.
6. Immediately after lifting load, ensure Jack mechanical load holding means is engaged.
7. Do not move while loaded.
8. Secure load with appropriate restraint device.
9. Do not adjust safety valve.
10. Wear ANSI-approved safety goggles and heavy-duty work gloves during use.
11. Keep clear of load while lifting and lowering.
12. Lower load slowly.
13. Do not use for aircraft purposes.
14. Inspect before every use; do not use if parts loose or damaged.
15. Keep your work area clean and well lit. Cluttered work areas invite accidents.
16. Do not allow anyone on the vehicle while using the Jack. Keep bystanders a safe distance away from
the vehicle and Jack.
17. Stay alert. Watch what you are doing, and use common sense when operating a Jack. Do not use a
Jack while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while
operating Jacks may result in serious personal injury.
18. Store idle Jacks out of reach of children and other untrained persons. Jacks are dangerous in the hands
of untrained users.
19. Jack service must be performed only by qualified repair personnel. Service or maintenance performed
by unqualified personnel could result in a risk of injury.
20. Before use, read manufacturer’s instruction manual for the vehicle you will lift.
21. Do not support both ends of the vehicle at the same time.
22. Before lowering the Jack, remove all tools and equipment from under the vehicle. The warnings,
precautions, and instructions discussed in this manual cannot cover all possible conditions and situations
that may occur. The operator must understand that common sense and caution are factors, which cannot
be built into this product, but must be supplied by the operator.
24. Keep labels, they contain important information and must always remain readable.
Rated Capacity 300 lb.
Maximum Lift Height 24”
Axle Width 36” - 50.5”