Operation Manual

8. Mounting

You can either use screws or adhesive strips to mount the

MAX! wall thermostat to a wall in the frame supplied or in-

tegrate it into an existing switch (please refer to sec. 9).

Adhesive strip mounting:

• Choose a site for installation. The surface on which you

are mounting the MAX! wall thermostat must be clean,

dry and greaseless.

• For mounting of the assembled MAX! wall thermostat,

attach the adhesive strips to the back side of the moun-

ting plate. You should be able to read the letters on the

back side (according to gure).

<PA66>

• Remove the protective lm from the adhesive strip.

• Press the assembled MAX! wall thermostat with the

back side to the wall in the position where it should sub-

sequently be attached.

Screw mounting:

• Choose a site for installation.

Make sure that electrical lines in the wall will not be

damaged.