Technical data

20 HN.50.Y1.02
This program pack offers the user several
different programs for meeting various require-
ments:
CIP Configuration Tool
Setting up a system consisting exclusively of
PVG CIP and Prof 1 CIP via a graphical user
interface. It takes the user through setting up
a system in an easily understandable and
instructive way. It cannot set up components
from a third party. However, the hydraulic
parameters in PVG CIP and Prof 1 CIP can be
adjusted with advantage even though CAN
components from a third party are involved.
CIP Downloading Utility
This program enables the adjustment of
CANopen parameters on all CANopen com-
ponents, direct in the OD (see example on
page 21).
System requirements • Windows 95 or higher
• Recommended Pentium microprocessor (or
higher)
• 16 Mb RAM (recommended)
• PEAK dongle (CAN communication inter-
face)
• PS/2 mouse port
Introduction to CIP Confi-
guration Tool
CANview
CANview is a program able to read the activity
taking place on the bus. It is therefore a tool
that can be used in servicing.
The program pack also contains a dongle
(PEAK) which is the interface between the PC
and CAN bus.
P.S. We recommend the use of PEAK’s
dongle in connection with our software.
Installation of CIP Configu-
ration Tool
To install a CIP Configuration Tool:
1. Insert the CD-ROM in the CD-ROM drive.
2. From Start, select Run and write
x:\setup.exe (where x is the CD-ROM
drive).
3. Follow the displayed instructions.