Operation Manual

SFX SERIES USER’S GUIDE
Rev 2.2 51
lost on the eth1 output. The rule in this case is to bind the static route to an interface that is not being used to
output the multicast traffic (via a multicast route). So in the above example, you must change the static route
to:
Interface: sat0
Gateway: 0.0.0.0
Destination: 224.1.1.1
Netmask: 255.255.255.255
When the Multicast Routing submenu item is selected under Data Delivery, the Multicast Routing page is displayed for
all network interfaces. A sample Multicast Routing page is shown in Figure 2- 24
.
Figure 2- 24 Multicast Routing Page
The columns in the Multicast Routing page are described under the Edit Default Route page (Figure 2- 25) and Edit
Multicast Routing Table page (Figure 2- 26
Aside from the Common Menu Items, the following menu items are available:
Menu Item Description
Show Table Selecting this button will always return you back to the Multicast Routing page, as shown in
Figure 2- 24.
Edit Default Route Selecting this button will enter the Edit Default Route page, as shown in Figure 2- 25.
Edit Table Selecting this button will enter the Edit Multicast Routing Table page, as shown in Figure 2- 26.
The following fields can be edited on the Edit Default Route page: