Operation Manual

SFX SERIES USER’S GUIDE

Rev 2.2 53

Figure 2- 26 Edit Multicast Routing Table Page

The following fields can be edited on the Edit Multicast Routing Table page:

Edit Field Description

Interfaces This check box selects the network interface that will be the destination of the routed multicast

IP packets. This selection allows you to specify exactly on which Ethernet interface the

multicast packets should be output. The selections available are the same as the Interface in

the Edit Default Route.

! Clicking on the “not” (!) check box negates the logic for the immediate edit field to the right of the

check box. For example, ! 192.168.10.10 for the Source IP would mean all IP addresses whose

source IP address is not 192.168.10.10.

SourceIP Enter a source IP Address in dotted decimal notation, here if you wish. “Any” is implied if no

Source IP is entered.

SourceIP Mask Enter a netmask for the source IP address. This field is optional and 255.255.255.255 is implied

if no SourceIP mask is entered.

MulticastIP Enter a multicast destination IP Address in dotted decimal notation. You must enter a valid

multicast address in this field.

MulticastIP Mask Enter a netmask for the multicast IP address. This field is optional and 255.255.255.255 is the

default if you do not enter a mask.

Action Select an action to be taken on the multicast IP packet being routed. The selections available

are the same as the Action in the Edit Default Rule.

In addition to the edit fields there are four table row manipulation keys:

Key Description

Add Add the entered information above the table to the table as the last row.

NOTE

The

SourceIP fields

are optional,

and “Any” is the

implied default

value.

NOTE

The

same limitations

apply for

Interfaces and

Action as in the

previous note.

NOTE: You

must press Send

Update to effect

any changes to

the multicast

routing table