User's Manual

33
RIOTRONIC X+
User Manual
Figure 29. Top view
6.2.6. NFC antenna
Logger is equipped with NFC communication antenna. NFC is used to communicate with
Blaster or read detonators RFID tags. NFC antenna is placed at the back of Logger’s case. It
is exact position is marked by the white rectangle.
Figure 30. Back view
6.2.7. Turning device on and off
To turn the device on press ON/OFF button and hold for about 3 seconds. Logger proceed
with initial auto test. If PIN checking is enabled, enter PIN and press OK or F2 button. Logger
starts with pattern list to pick the Active Pattern.
To turn the device off press ON/OFF button and then confirm with OK or F2 button. If
ON/OFF button is pressed and held for longer than 3 second, Logger will be turned off
without confirmation screen.
6.2.8. Active pattern
Active pattern is a pattern which Logger is working on. It is used to programming new
detonators, for editing, listing and testing.