User's Manual

49
RIOTRONIC X+
User Manual
Figure 47. NFC antenna
7.2.8. Turning device on and off
To turn the device on press ON/OFF button and hold for about 3 seconds. Blaster proceed
with initial auto test. If PIN checking is enabled, enter PIN and press OK or F2 button. Blaster
starts with Logger connection screen to download the pattern.
To turn the device off press ON/OFF button and then confirm with OK or F2 button. If
ON/OFF button is pressed and held for longer than 3 second, Blaster will be turned off
without confirmation screen.
7.2.9. Receive data
Blasting procedure starts with receiving data from Loggers. Depending on settings it can be
by NFC (wireless) or USB (wired).
To transfer data by NFC Transfer data / Send option have to be chosen on Logger and
pattern must be selected. Then Logger should be put on the Blaster and NFC antennas
should be aligned. Transfer will start automatically.
If USB transfer is set, Transfer data / Send option have to be chosen on Logger and pattern
must be selected. Then USB cable should be connected between Logger and Blaster’s USB1
socket. Then OK or F2 key should be pressed.
Figure 48. Receive data through NFC