User's Manual

75
RIOTRONIC X+
User Manual
8.6.3.3. System info
Displays Remote’s serial number, firmware version, date of last battery changes and revision.
8.6.3.4. PIN settings
It is to change user or admin PIN. To change admin PIN, it must be entered when the device
is starting.
PIN can be from 1 to 8 digits long or empty. If user PIN is empty, Logger will not ask for PIN
on start.
Admin PIN can be entered as old PIN, when user PIN is changed.
8.6.3.5. Time and date
Current time and date can be set there.
8.6.3.6. Language
Language can be changed there.
8.6.3.7. Brightness
Display brightness can be changed. The value can be set by left and right arrow key or
entered with numeric keys. OK or F2 key have to be pressed to store the value.
8.6.3.8. Buttons beep
If this function is on, there is a beep signal with every key pressed. If this is off, beep signal
is only for important notifications.
8.6.3.9. Reset WiFi
This option is to reset WiFi modem to default configuration. It is used to enable direct
connection between Remote and PC and set new WiFi configuration.
When this option is chosen WiFi modem will create Access Point with network called
MAXAM_R_XX, where XX are last two digits of its serial number. PC should be connected to
this network. Password is MAXAMWIFI. Web browser should be started and 192.168.12.100
should be entered in the address bar. Login page should be opened.
Figure 99. Login page to WiFi configuration