Instructions / Assembly

F66

INSTRUCTION MANUAL

Take out the lampshades

and round iron frames.

STEPS TO ASSEMBLE THE LAMPSHADE

MADE IN CHINA

Once the lampshade is

positioned correctly, screw the

finial into place to hold it

securely.(lf the lamp shade is

slanted,adjust the base of the

finial to make it level).

Install the harps onto the lamp

base by positioning them over the

sockets. Next,insert the bulb into

the socket and rotate it clockwise

until it is securely in place.(bulbs

are notincluded).

For an oblique barrel-shaped

lampshade, align the lamp frame

by placing its short edge on the

corresponding short side of the

lampshade and the long edge

on the corresponding long side.

Align the frame with the edge of the

lampshades and secure it in place using

fasteners. Repeat the process for the

second frame. Ensure that the frames are

firmly attached and the lampshades are

tightly stretched.

PAGE 1
STEPS TO ASSEMBLE THE LAMPSHADE Take out the lampshades 1 and round iron frames. Align the frame with the edge of the lampshades and secure it in place using fasteners. Repeat the process for the second frame. Ensure that the frames are firmly attached and the lampshades are tightly stretched. F66 INSTRUCTION MANUAL 2 For an oblique barrel-shaped lampshade, align the lamp frame by placing its short edge on the corresponding short side of the lampshade and the long edge on the corresponding long side.
PAGE 2
Applicable bulb type:A19,A60,T45,ST58... (Excluding bulb) 1.Unpack all parts from cartons carefully. 2.Carefully pull-out excess power cord from the lamp base while assembling to prevent the cord from becoming twisted. 3.Tighten the lamp socket(A) into the MDF(B) until tight. 4.Tighten the tube(C) into the MDF(B) until tight. 5.Place the MDF(D) into the tube(C),then tighten the tube(E) into the tube(C) until tight. 6.Place the MDF(F) into the tube(E),then tighten the tubes(G) into the tube(E) until tight.