User Manual

5251

Check Belt Tightness

Hold child restraint at the belt path

with your weaker hand.

Push and pull from side to side. It

should not move more than 2.5 cm

(1 in.).

Tighten Tether

Push ﬁ rmly on the back of the seat

and pull the tether strap to remove

all slack and create tension on the

strap.

Tighten Belt

Place hand in child restraint. Firmly push child restraint down

while pulling the free end of the belt parallel with the belt path

through the belt path opening as shown.

If it moves more than 2.5 cm (1 in.), you can try:

A. Putting your knee in the car seat and pulling the belt tighter.

B. Reinstalling the child restraint.

C. Changing to a different seating location.

D. Switching to vehicle belt installation.

Attach Lower Anchor/UAS

Connector to Vehicle’s Lower/

UAS Anchor

Review your vehicle owner’s manual

for lower/UAS anchor locations and

lower anchor/UAS belt use.

Make sure arrows on

connectors are facing up.

Fasten one lower anchor/UAS belt

connector to the anchor located in

the vehicle seat bight.

Repeat for other side of child

restraint.

Finished!

Check the tightness of the install often to make

sure it has not loosened.

Securing Child in Car Seat

To properly secure your child in the car seat, see

pages 53-55. Check your child’s ﬁ t often and

make any needed adjustments to the car seat as

they grow.

Replace Headrest Pad

Fasten all the headrest pad fasteners. Adjust the headrest/

harness back to the correct position for your child. See page 9.