User Manual

Easy-Out Buckle Cover
To install Easy-Out buckle cover, slide buckle
into opening in front of buckle cover. Then be
sure to slide buckle cover itself through the
buckle slot in only the seat pad.
NOTE: Buckle cover only goes through slot in pad and NOT through
buckle slot in shell. It lays fl at underneath the pad as shown.
To remove Easy-Out buckle cover, pull up on buckle cover and slide
it off of the buckle and pull it out of the buckle slot in the seat pad.
Accessory Use
3 4
Head and Back Pillow
The head and back pillow must be used
together.
To remove head pillow, pull it out from behind
the back pillow.
To remove back pillow, loosen the harness
straps and slide pillow out from behind the
harness straps.
Small Infant Positioning Pillow
When used, the small infant positioning pillow
must be used with the back pillow.
This pillow helps position your infant in the seat in order to achieve
proper harness fi t.
To determine if the pillow is needed:
1. Place headrest in lowest position.
2. Place infant in car seat without the pillow.
3. Make sure the infant’s bottom and back are fl at against the car seat.
Removable Cupholders
The cupholders are top-rack dishwasher
safe.
To remove cupholder, twist the cupholder
counterclockwise. Pull it out of slot in shell.
To install cupholder, align tabs on bottom of
cupholder with slots in shell. Twist clockwise to
lock in place.
Easy-Out Harness Covers
Harness covers help provide comfort to the
neck. If the harness covers will not allow proper
positioning of the chest clip or interfere with
getting a tight enough harness fi t for a smaller
baby, remove and do not use.
Store until your child is large enough to use
these harness covers while maintaining a
properly fi tting harness.
To remove Easy-Out harness covers, see
pages 57-60.
Only For Use in Rear-Facing Mode
Only For Use in Rear-Facing Mode
For Use in Rear-Facing or
Forward-Facing Mode
Use Pillow if
Shoulder Harness
Slots are Above
Shoulders
Do Not Use
Pillow if Shoulder
Harness Slots are
At or Below
Shoulders
Check often to see how much your infant has grown. Remove the infant
pillow once they can sit in the car seat without the infant pillow and the
harness slots are at or below their shoulders AND you can still achieve
a snug harness fi t.
To learn how to check harness tightness, see pages 53-55.
Front View
Back View